Enable Isolation Mode Between Folders and Workspaces¶

The specific setup steps are as follows:

Check if the global management Helm repository exists.
```
helm repo list | grep ghippo
```
If the result is empty or shows the following error, proceed to the next step; otherwise, skip the next step.
```
Error: no repositories to show
```

Add and update the global management Helm repository.

helm repo add ghippo http://{harbor url}/chartrepo/{project}
helm repo update ghippo

Set environment variables for easier use in the following steps.

# Helm --set parameter backup file
export GHIPPO_VALUES_BAK="ghippo-values-bak.yaml"

# Get the current version of ghippo
export GHIPPO_HELM_VERSION=$(helm get notes ghippo -n ghippo-system | grep "Chart Version" | awk -F ': ' '{ print $2 }')

Backup the --set parameters.

helm get values ghippo -n ghippo-system -o yaml > ${GHIPPO_VALUES_BAK}

Turn on the isolation mode switch between Folder and WS.

Note

If possible, you can use the yq command:

yq -i ".apiserver.userIsolationMode = \"Folder\"" ${GHIPPO_VALUES_BAK}

Or you can use the vim command to edit and save:

vim ${GHIPPO_VALUES_BAK}

USER-SUPPLIED VALUES:
...
# Just add the following two lines
apiserver:
  userIsolationMode: Folder

Run helm upgrade to apply the configuration.

helm upgrade ghippo ghippo/ghippo \
  -n ghippo-system \
  -f ${GHIPPO_VALUES_BAK} \
  --version ${GHIPPO_HELM_VERSION}

Use kubectl to restart the global management Pod to apply the configuration.
```
kubectl rollout restart deploy/ghippo-apiserver -n ghippo-system
```

Enable Isolation Mode Between Folders and Workspaces¶

Comments