Skip to content

Permission Scan

To use the Permission Scan function, you need to create a scan policy first. After executing the policy, a scan report will be automatically generated for viewing.

Create a Scan Policy

  1. On the left navigation bar of the homepage in the Container Management module, click Security Management .

  2. Click Permission Scan on the left navigation bar, then click the Scan Policy tab and click Create Scan Policy on the right.

  3. Fill in the configuration according to the following instructions, and then click OK .

    • Cluster: Select the cluster to be scanned. The optional cluster list comes from the clusters accessed or created in the Container Management module. If the desired cluster is not available, you can access or create a cluster in the Container Management module.

    • Scan Type:

      • Immediate scan: Perform a scan immediately after the scan policy is created. It cannot be automatically/manually executed again later.
      • Scheduled scan: Automatically repeat the scan at scheduled intervals.

    • Number of Scan Reports to Keep: Set the maximum number of scan reports to be kept. When the specified retention quantity is exceeded, delete from the earliest report.

Update/Delete Scan Policies

After creating a scan policy, you can update or delete it as needed.

Under the Scan Policy tab, click the ⵗ action button to the right of a configuration:

  • For periodic scan policies:

    • Select Execute Immediately to perform an additional scan outside the regular schedule.
    • Select Disable to interrupt the scanning plan until Enable is clicked to resume executing the scan policy according to the scheduling plan.
    • Select Edit to update the configuration. You can update the scan configuration, type, scan cycle, and report retention quantity. The configuration name and the target cluster to be scanned cannot be changed.
    • Select Delete to delete the configuration.

  • For one-time scan policies: Only support the Delete operation.

View Scan Reports

  1. Under the Security Management -> Permission Scanning -> Scan Reports tab, click the report name.

    Clicking Delete on the right of a report allows you to manually delete the report.

  2. View the scan report content, including:

    • The target cluster scanned.
    • The scan policy used.
    • The total number of scan items, warnings, and errors.
    • In periodic scan reports generated by periodic scan policies, you can also view the scan frequency.
    • The start time of the scan.
    • Check details, such as the checked resources, resource types, scan results, error types, and error details.

Comments